Subaru Forester: Brake fluid
Checking the fluid level
Checking the fluid level
1) “MAX” level mark
2) “MIN” level mark
Check the fluid level monthly.
Check the fluid level on the outside of the reservoir. If the level is below “MIN”, add the recommended brake fluid to “MAX”.
Use only brake fluid from a sealed container.
- Never let brake fluid contact your eyes because brake fluid can be harmful to your eyes. If brake fluid gets in your eyes, immediately flush them thoroughly with clean water. For safety, when performing this work, wearing eye protection is advisable.
- Brake fluid absorbs moisture from the air. Any absorbed moisture can cause a dangerous loss of braking performance.
- If the vehicle requires frequent refilling, there may be a leak. If you suspect a problem, have the vehicle checked at your SUBARU dealer.
- When adding brake fluid, be careful not to allow any dirt into the reservoir.
- Never splash the brake fluid over painted surfaces or rubber parts.
Alcohol contained in the brake fluid may damage them.
- Be careful not to spill brake fluid when adding it. If brake fluid touches the exhaust pipe, it may cause a bad smell, smoke, and/or a fire. If brake fluid gets on the exhaust pipe, be sure to wipe it off.
Recommended brake fluid
Refer to “Fluids”.
Never use different brands of brake fluid together. Also, avoid mixing DOT 3 and DOT 4 brake fluids even if they are the same brand.
Power steering fluid
See also:
Road warning
Hazard warning flasher The hazard warning flasher serves as a warning to other
drivers to exercise extreme caution when approaching, overtaking, or passing your
vehicle. It should be used whenever emergency repairs are being made or when the
...
Front seats
- Never adjust the seat while driving
to avoid the possibility of
loss of vehicle control and of
personal injury.
- Before adjusting the seat, make
sure the hands and feet of rear
seat passengers and cargo are
clear of the adjusting ...
