Subaru Forester: Antenna system

Subaru Forester / Subaru Forester 3rd Gen Owner's Manual / Audio / Antenna system

Roof antenna

- Be sure to lower the antenna rod

- Be sure to lower the antenna rod before entering garages, parking towers and other locations with low ceilings.

- Remove the antenna rod before washing your car at a car wash. If the antenna rod is left attached, it may scratch the roof.

- When reinstalling the removed antenna rod, be sure to fully tighten it.

1) Unscrew

1) Unscrew
2) Remove

The roof antenna is installed in the center at the rear part of the roof.

It is possible to remove the antenna rod by unscrewing it from its base.

FM reception

Although FM is normally static free, reception can be affected by the surrounding area, atmospheric conditions, station strength and transmitter distance. Buildings or other obstructions may cause momentary static, flutter or station interference.

If reception continues to be unsatisfactory, switch to a stronger station.

Installation of accessories

Always consult your SUBARU dealer before installing a citizen band radio or other transmitting device in your vehicle.

Such devices may cause the electronic control system to malfunction if they are incorrectly installed or if they are not suited for the vehicle.

Air filtration system
Audio set

See also:


Tire pressure monitor system (TPMS)
The Tire Pressure Monitor System (TPMS) will warn the driver of a low tire pressure based on the vehicle recommended cold placard pressure. The tire pressure will vary with temperature by about 1 psi (6.9 kPa) for every 12°F (6.5°C). This m ...

Second seat
When a person is sitting in the second seat, raise the head restraints to height at which it lock in position. Refer to “Head restraints” on page 2-22. NOTE: ● It is possible to adjust each side of the second seats forward and backward ...